梁の穴の選択と修正

単一穴の修正

1.以下のいずれかを実行します。

矢印ツールを有効にして、穴の中心をクリックします。

他のいずれかのツールを有効にし、Shiftキーを押しながら穴の中心をクリックします。

https://helpcenter.graphisoft.com/jp/wp-content/uploads/sites/3/archicad-22-reference-guide//Select1BeamHole.png   https://helpcenter.graphisoft.com/jp/wp-content/uploads/sites/3/archicad-22-reference-guide//Select1BeamHoleDone.png

2.[選択した梁の設定]ダイアログボックスの[穴]パネルを開き、選択した穴の形状およびサイズを修正します(または情報ボックスのコントロールを使用します)。

https://helpcenter.graphisoft.com/jp/wp-content/uploads/sites/3/archicad-22-reference-guide//Select1BeamHoleSettings.png 

3.必要に応じて、穴の位置をグラフィカルに変更してください。

梁に沿って穴を左右に移動します(平面図または3D)。

Z軸に沿って穴を上下に移動します(3D)。

https://helpcenter.graphisoft.com/jp/wp-content/uploads/sites/3/archicad-22-reference-guide//MoveBeam.png 

穴の修正

1.梁を選択します。梁の全ての穴も選択されます。

2.[選択した梁の設定]ダイアログボックスの[穴]パネルを開き、選択した全ての穴を同時に修正します(または情報ボックスのコントロールを使用します)。

https://helpcenter.graphisoft.com/jp/wp-content/uploads/sites/3/archicad-22-reference-guide//EditAllBeamHoles.png 

湾曲梁の穴

(梁のいずれかの終端から所定の距離をおいて)直線梁に穴を配置し、梁を湾曲させる場合を考えます(下図を参照)。

https://helpcenter.graphisoft.com/jp/wp-content/uploads/sites/3/archicad-22-reference-guide//ArcBeamHole1.png 

[梁の穴の位置]ダイアログボックスでは、湾曲梁の穴の新しい位置を処理する方法を選択できます。

https://helpcenter.graphisoft.com/jp/wp-content/uploads/sites/3/archicad-22-reference-guide//BeamsHolesPosition.png 

[距離を維持]:穴と穴に最も近い梁の終端との距離(中心の梁円弧に沿って測定)は変更されません。

https://helpcenter.graphisoft.com/jp/wp-content/uploads/sites/3/archicad-22-reference-guide//ArcBeamHole2.png 

[比率を維持]:梁の長さを基準として、穴の配置を一定に保ちます。

https://helpcenter.graphisoft.com/jp/wp-content/uploads/sites/3/archicad-22-reference-guide//BeamsHolesPositionProp.png