Polyline Tool Settings

For a description of generic settings common to all tools in the Toolbox, see Working in Tool Settings Dialog Boxes.

The Polyline tool creates a single element by drawing a series of segments.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/140_userinterfacetoolsettings/Polyline_Tool.png 

Geometry methods are: Polyline, Rectangle and Rotated Rectangle.

For more information on Polylines, see Drawing Polylines and Chained Lines.

Polyline General Settings Panel

The General Settings panel is similar to those of the Line, Arc/Circle, Polyline and Spline tools.

See description at Line General Settings Panel.

For polylines only: Choose a preference for handling the pattern of a dashed line type.

See Dashed Polylines: by Segment or Continuous

Polyline Properties Panel

See description at Line Properties Panel.

  • Was this Helpful ?
  • YesNo
Relevant topics
Polyline editing functions refined
ARCHICAD 24 improves polyline editing: •The Intersect command now works between two or more independent Polylines, and between Polyline and Wall/Beam/Line/Arc. •When intersecting Polylines: if only one ends intersects after the first Intersect command, repeat the command to ...
How to Fillet/Chamfer a Polyline
tip by Stuart Rose, New Zealand   This is one of those handy tips can save a lot of time to newcomers. Instead of the tedious job of exploding your polyline to fillet with arcs, follow the below steps: select the polyline pick a corner node (not…
Place Railing: Basic Polyline Input
Railing input is similar to polyline input, and consists of Nodes and Segments along a Railing Reference Line. 1.Activate the Railing Tool from ...