Monolithic Flight and Landing Structures

These settings are available if you chose a Monolithic Structure type for the Flight and/or Landing.

See Choose Structure Type.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/Monolithic.png 

Monolithic Flight Structure: Choose Shape

Use the four buttons to choose a shape for the bottom of a Monolithic flight. From left:

Flat

Stepped

Variable Thickness (at each end)

Filled

Below, enter values for the thickness/offset variables as applicable. Note the feedback in the Preview window.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/MonolithicShape.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/MonoStructures3D.png 

Monolithic Flight Shapes

Monolithic Support Component Settings

Use this panel to set attributes, including Building Material, for the Monolithic Flight/Monolithic Landing.

Check Uniform Flight and Landing Attributes to apply the same attributes to both Monolithic structures (Flight and Landing).

Note: The “Uniform attributes” checkbox applies only to Structure attributes, not its thickness.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/MonoSupportSettings.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/MonoLanding.png 

Draining on Flight/Draining on Landing

This panel is available for Monolithic structures only.

Check Draining to place a Draining on the left and/or right side of the Stair structure (available for both Flight and Landing).

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/DrainingOnFlight.png 

Check Uniform Draining Settings on Flight and Landing to apply settings to both Stair structures.

For Draining on Flight:

Choose Draining Type (Flat or Stepped) for both Flight and Connections. This setting will be used for the Draining on Landing, if any.

Set Draining width/depth values as applicable, and an optional offset.

If needed, apply a Surface override to the Draining.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/Draining3D.png 

Monolithic Stair with Draining on Both Sides

  • Was this Helpful ?
  • YesNo