Column Tool Settings: Preview and Positioning

The Column Settings dialog box is divided into five pages.

The Preview section remains visible on all pages, and reflects your settings modifications.

Navigate among the pages using the tree structure on the left:

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/040_elementsvb/ColumnDefaultSettings.png 

Core Width/Height

For a simple (single-segment) Column, enter the core’s horizontal and vertical dimensions.

Note: For Columns with a rectangular cross-section, use the chain icon to constrain them to the same value.

For a circular column, enter a diameter.

Column height

Shows the Column’s total height.

For an unlinked Column, set its height here.

For a top linked Column: this field is not editable. Column height depends on the settings in the Positioning panel below.

Column Positioning Panel

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/040_elementsvb/ColumnPositioning.png 

By default:

The Column top is linked to one story up

The Home Story is the current story.

Top Link

Use this control to do one of the following:

Top link the Column relative to its Home Story (Home+1, Home+2, etc.)

If you later modify the positions and heights of stories in your projects, the heights of any linked Columns will follow automatically.

Choose Not linked to make it a fixed-height Column. Define its height in Column height field above.

Offset from Top Linked Story

You can offset the Column top from its top linked story.

The offset value can be positive, negative or zero.

The offset field is not available if the Column has no top link.

You can also offset the Column bottom from the Home Story, in either direction.

The Column height value (seen in the Preview section of Column settings) is affected by the top and bottom offsets, if any.

Home Story

See Home Story.

Bottom Elevation [to Reference level]

Calculates the current elevation of the Column’s reference line, as measured from the Reference level (by default, this Reference level is Project Zero).

Click the pop-up arrow to change the Reference level, if needed.

Note: Reference levels are defined at Options > Project Preferences > Reference Levels.

For general information on levels, see Reference Levels Preferences.

Note: This is a calculated value, not a link. If you change the Reference level, the Column will not change its position.

Column Slant Angle

See Create a Slanted Column.

Wrapping Method

See Columns and Composite Walls: Wrapped or Unwrapped.

Relation to Zones

See these topics:

Calculating Zone Area and Zone Volume

Relation to Zones

  • Was this Helpful ?
  • YesNo
Relevant topics
Beam Tool Settings: Preview and Positioning
The Beam Settings dialog box is divided into five pages. The Preview section remains visible on all pages, and reflects your settings modifications. For a multi-segmented Beam, the Preview section includes its Structure settings. Navigate among the pages using the tree structure on the ...
Preview and Positioning Panel
Set values for the element's position in the model: •its relative height (measured from the current or home story) •absolute height (from Project Zero or other defined reference level) •rotation angle •mirrored placement of element •Home Story