Post Settings (Railing Tool)

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/040-elementsvb/PostSettings.png 

From the popup, choose a GDL component to be placed as a Post at each Node of the Railing, or choose None from the pop-up (if you do not want to place a physical Post).

To define settings for the GDL component, use the panel below. See Post Component Settings (Posts/Inner Posts/Balusters).

In addition to predefined content, you can save a custom component as a Post.

For details, see Custom Sub-Elements for Stairs and Railings.

Post Top/Bottom Offset

Enter a bottom and top offset value for the Post.

Use the pop-up to define how to calculate the offset:

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/040-elementsvb/PostOffset.png 

Segment Top: Set the offset value relative to the Segment height.

Note: Segment height is defined in Segment Settings. See Segment Height and Vertical Offset.

Absolute: Enter the Post’s absolute height. The Post is then offset from the Segment top accordingly.

  • Was this Helpful ?
  • YesNo
Relevant topics
Inner Post Settings (Railing Tool)
Use these Settings to add and define any number of Inner Posts in the Pattern Editor. Inner Posts are located between Segment Nodes (as opposed ...