Stretch 1D Member

Stretch the 1D Member along its length (local X axis), so that it can connect to another nearby Member.

For each stretch adjuster, you can set a maximum allowed stretch distance (“Max. stretch”). This distance is measured between unadjusted 1D Member Nodes and/or unadjusted 2D Member planes.

Note: The defined tolerances are length-type values: the units specified for Length in Preferences > Working Units apply.

 

STRETCH 1D MEMBER TO 1D MEMBER

Stretch 1D to 1D
(one to the other)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/OneToOther00258.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/1D1DStretch.png 

Stretch 1D to 1D
(to each other)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/ToEachOther00259.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/1D1DStretchMulti.png 

 

STRETCH 1D MEMBER TO 2D MEMBER

Stretch 1D to 2D
(one to the other)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/OneToOther00260.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/1D2DStretch.png 

Stretch 1D to 2D
(to each other)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/ToEachOther00261.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/2D1DStretchMulti.png 

1D Column is stretched down to reach the 2D Slab;
Slab edge is stretched to reach the side Beam

See also Adjust Connected Ends.

  • Was this Helpful ?
  • YesNo
Relevant topics
Stretch 2D Member
Stretch part or all of one edge of a 2D Member polygon, so that it can connect to another nearby Member. For each stretch adjuster, you can set a maximum allowed stretch distance (“Max. stretch”). This distance is measured between unadjusted 1D Member Nodes and/or unadjusted 2D ...
Cutback 1D Member
Cut back 1D Member along its length (Local X axis), so that it can connect as needed to another nearby Member.   CUTBACK 1D MEMBER TO 1D MEMBER Cutback 1D to 1D (one to the other)     Cutback 1D to 1D (to each ...
Cutback 2D Member
Cuts back all or part of the edge of a 2D Member plane, so that it can connect as needed to another Member.   CUTBACK 2D MEMBER Cutback 2D to 1D (one to the other)     Cutback 2D to 1D (to each other) ...