Cantilevered Flight and Landing Structure

These settings are available if you chose a Cantilever Structure type for the Flight and/or Landing.

See Choose Structure Type.

Choose a Cantilever Component type - e.g. Bracket or Block.

Use the Cantilevered Component Panel to configure the chosen structure:

Set cantilever structure on left, right, or both sides of Stair

Add an optional Tread Plate

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/040_elementsvb/CantileverSettings.png 

Use Edit Mode to add an optional Wall Fixing to Flight or Landing, as shown below:

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/040_elementsvb/CantileverFlightStructure.png 

Add Wall Fixing to Cantilever Flight (Select and Edit Flight Structure in Edit Mode)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/040_elementsvb/CantileverLandingStructure.png 

Add Linear Fixings to Cantilever Landing Segments (Select and Edit Landing Structure in Edit Mode)

  • Was this Helpful ?
  • YesNo