Simple Extruded Vault: Parallel to the Floor Plan

Use this method to place a vault-shaped Shell profile, then extrude it graphically.

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/040-elementsvb/ShellExtrudeDone3D.png 

The Shell’s profile here is always a half-circle (vault). (You can edit the profile later.)

1.Activate the Shell Tool and choose the extruded geometry method with simple input method.

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/040-elementsvb/ShellVaultChoice.png 

On the Floor Plan or 3D Window:

2.Click twice to define the Shell’s extrusion length.

3.Click a third time to define the width of the Shell Profile.

4.The Shell is complete.

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/040-elementsvb/ShellExtrude1.png      //helpcenter.graphisoft.com/wp-content/uploads/ac22_help/040-elementsvb/ShellExtrude2.png

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/040-elementsvb/ShellExtrudeDone2D.png      //helpcenter.graphisoft.com/wp-content/uploads/ac22_help/040-elementsvb/ShellExtrudeDone3D00047.png

  • Was this Helpful ?
  • YesNo