Cutback 1D Member

Cut back 1D Member along its length (Local X axis), so that it can connect as needed to another nearby Member.

 

CUTBACK 1D MEMBER TO 1D MEMBER

Cutback 1D to 1D
(one to the other)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/081_structuralanalyticalmodeltools/OneToOther00251.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/081_structuralanalyticalmodeltools/1D1DCutback.png 

Cutback 1D to 1D
(to each other)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/081_structuralanalyticalmodeltools/ToEachOther00252.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/081_structuralanalyticalmodeltools/1D1DCutbackMulti.png 

 

CUTBACK 1D MEMBER TO 2D MEMBER

Cutback 1D to 2D
(one to the other)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/081_structuralanalyticalmodeltools/OneToOther00253.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/081_structuralanalyticalmodeltools/1D2DCutback.png 

Cutback 1D to 2D
(to each other)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/081_structuralanalyticalmodeltools/ToEachOther00254.png 

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/081_structuralanalyticalmodeltools/1D2DCutbackMulti.png 

Column is cut back to the Slab
Slab edge is cut back to the Beams

Partial cutback

Check this to cut back only part of the 2D Member edge.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/081_structuralanalyticalmodeltools/1D2DCutbackPartial.png 

Min. segment length

If Partial Cutback is enabled: An edge part will be cut back only if it is at least this long.

See also Adjust Connected Ends.

  • Was this Helpful ?
  • YesNo