Basic Morph Editing: Bulge

1.Click on any face of a Morph.

Note: Choose the clicked point carefully, because it will be the centerpoint of the circle out of which you will draw the bulge.

2.From the pet palette, choose the Bulge command.

3.Drag the cursor to define the radius of the bulge.

A small radius will give you a smaller, sharper outcropping.

Use a larger radius for a more gentle rounded result.

4.Click to complete the radius.

5.Now drag the cursor to bulge the Morph in or out.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/bulge_0.png     https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/bulge_1.png

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-23-reference-guide/040_elementsvb/bulge_2.png 

  • Was this Helpful ?
  • YesNo
Relevant topics