Energy Source Factors (Energy Evaluation)

Open this dialog box from:

the Model Review Palette’s pop-up at the top right, or

Design > Energy Evaluation > Energy Source Factors.

Primary Energy And CO2 Emission Factors

For each energy source, default values are shown for primary energy and CO2 emission factors. These default values, which vary according to Project Location, are based on standard DINV-18599.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/110_energyevaluation/Energy_Source_Factors_Only.png 

Use these default values, or enter other region-specific data if available.

Sources of Electricity Production

At the bottom of the Energy Source Factors dialog, define the building’s source or multiple sources of electricity. Click on a listed Source item and use the dropdown to specify the source of electricity (Natural gas, Propane, Oil, Wood, Coal, Nuclear energy, Wind energy, Solar energy, Water energy or Unknown).

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/110_energyevaluation/ElectricitySource.png 

If you use more than one energy source, click the + (plus) button, then choose an additional source. Define the Proportion of each source used so that they add up to 100%. To remove a row, click the - (minus) button.

  • Was this Helpful ?
  • YesNo
Relevant topics
Energy Performance Evaluation
The following topics detail the evaluation process and the resulting reports of ARCHICAD’s Energy Evaluation feature. Start Energy ...