Snap (1D to 1D)

The Snap adjustment is available only to adjust a 1D Member to another 1D member, “one to the other” only.

Snap connects a 1D Member to another nearby 1D Member node, if the Members are not in the same plane. The Snap adjuster combines stretch, offset and rotation. This can be useful, for example, in connecting diagonal bracing to supporting columns.

See also Example 3: Snap.

 

SNAP 1D MEMBER TO 1D MEMBER

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/OneToOther00290.png 

“one to the other” only

 

Find Node within

Find the target node within this range. (Nodes located farther away will be ignored.)

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-25/090_structuralanalyticalmodeltools/SnapOptions.png 

See also Adjust Connected Ends.

  • Was this Helpful ?
  • YesNo
Relevant topics
Snap to Grid
The Grid Snap function (Alt+S) assists in the precise graphic alignment of elements, even at low zoom levels. When grid snap is active, the ...
Set up Snap Grid
The Snap Grid is an invisible grid that you can use optionally to make input easier, by having the cursor snap to a predefined distances. ...
Snap Points on Temporary Vector
You can display Snap Points on a temporary vector used while drawing elements. The method can be activated with the Snap Point icon among the ...