Stair Structure Listing Parameters

Parameter

Short Description

Long Description

 

Construc­tion Type

Type of Stair Structure: Monolith, Beam, Stringers, or Cantilevered

 

 

Drain Length

Length of Draining (Monolith Structure only)

 

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/060-elementparameters/379_drain_length.png 

Drain Posi­tion

Position of Draining (Right and/or Left, relative to direction of Stair baseline).

Assign in "Draining on Flight" Panel of Stair Settings (Monolithic Structure only)

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/060-elementparameters/380_drain_position.gif 

Stair Struc­ture Profile Height

Profile dimension of the supporting Structure.

 

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/060-elementparameters/381_profile_height.png 

Stair Struc­ture Profile Width

Profile dimension of the supporting Structure.

 

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/060-elementparameters/382_profile_width.png 

Stair Struc­ture Profile WxH

Profile dimension of the supporting Structure.

 

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/060-elementparameters/383_profile_WxH.png 

Secondary Thickness

As in Settings - for Monolithic Flight Structures using a Stepped or Variable shape.

 

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/060-elementparameters/384_secondary_thickness.gif 

Shape Type

Shape of Stair bottom: Straight, Stepped, or Flat.

 

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/060-elementparameters/385_stair_shape_type.gif 

Stair Struc­ture Posi­tion

For Stringers: Left or Right position. All other Structures are listed as "Under Stair."

 

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/060-elementparameters/387_stringer_position.gif 

Stair Struc­ture Thick­ness

Thickness of Structure element (as in Settings).

 

 

  • Was this Helpful ?
  • YesNo
Relevant topics
Split Stair Structure
Use this function to obtain multiple Structure types for a single Stair flight. This command is available in Edit mode, in the 3D window only: ...