Basic Morph Editing: Fillet/Chamfer a Morph

You can fillet or chamfer the corners and edges of Morphs, in 2D or 3D windows.

Note that a fillet or chamfer operation has the effect of created one or more new Morph faces. These new faces will always “inherit” the default surface of the original Morph.

Fillet/Chamfer a Morph Corner

1.Select a Morph and bring up the pet palette at one of its corners.

2.Choose the Fillet/Chamfer Corner command and apply the desired options.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/040_elementsvb/ChamferCorner1.png     https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/040_elementsvb/ChamferCorner2.png

Check the box to apply to all corners of the Morph:

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/040_elementsvb/ApplyToAllCorners.png 

Fillet/Chamfer Morph Edges

1.Bring up the pet palette on the edge of a selected Morph (or on one or more selected edges).

2.Choose the Fillet/Chamfer Edge(s) command and apply the desired options.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/040_elementsvb/FilletEdge1.png     https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/040_elementsvb/FilletEdge2.png

If you have selected an entire Morph, you can check the box to apply the fillet/chamfer to all edges:

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/040_elementsvb/ApplyToAllEdges.png 

Custom Resolution for Fillet

By default, the Fillet resolution is set to 4 (this is best displayed in wireframe):

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/040_elementsvb/DefaultFillet.png 

For different results, adjust the Fillet resolution up or down:

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-24-reference-guide/040_elementsvb/CustomResolution.png 

  • Was this Helpful ?
  • YesNo
Relevant topics
Create a Fillet or Chamfer
Use the Edit > Reshape > Fillet/Chamfer command to fillet or chamfer the intersection of two straight lines or walls, or the ...
How to Fillet/Chamfer a Polyline
tip by Stuart Rose, New Zealand   This is one of those handy tips can save a lot of time to newcomers. Instead of the tedious job of exploding your polyline to fillet with arcs, follow the below steps: select the polyline pick a corner node (not…