1D 부재 늘이기

길이를 따라(로컬 X축) 1D 부재를 늘이므로, 부근의 다른 부재와 연결될 수 있습니다.

각 늘이기 조정기마다, 늘이기 거리의 최대 허용치를 설정할 수 있습니다("최대 늘이기"). 이 거리는 조정되지 않은 1D 부재 노드 그리고/또는 조정되지 않은 2D 부재 평면 사이를 측정하는 거리입니다.

주의: 정의된 허용오차는 길이 유형의 값입니다. 환경설정 > 작업 단위에서 길이에 대해 명시된 단위가 적용됩니다.

 

1D 부재를 1D 부재로 늘이기

1D에서 1D로 늘이기
(하나에서 다른 하나로)

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/081_structuralanalyticalmodeltools/OneToOther00242.png 

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/081_structuralanalyticalmodeltools/1D1DStretch.png 

1D에서 1D로 늘이기
(서로)

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/081_structuralanalyticalmodeltools/ToEachOther00243.png 

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/081_structuralanalyticalmodeltools/1D1DStretchMulti.png 

 

1D 부재를 2D 부재로 늘이기

1D에서 2D로 늘이기
(하나에서 다른 하나로)

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/081_structuralanalyticalmodeltools/OneToOther00244.png 

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/081_structuralanalyticalmodeltools/1D2DStretch.png 

1D에서 2D로 늘이기
(서로)

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/081_structuralanalyticalmodeltools/ToEachOther00245.png 

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/081_structuralanalyticalmodeltools/2D1DStretchMulti.png 

1D 기둥은 아래로 늘어나 2D 슬래브에 닿습니다.
슬래브 모서리는 늘어나 옆쪽 보에 닿습니다.

연결된 단부 조정도 참조.

  • Was this Helpful ?
  • YesNo