기본 모프 편집: 오프셋 모프 테두리(들)

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/040_elementsvb/BoxMorphBegin.png 

1.모프를 선택합니다.

2.아무 테두리에서 펫 팔레트를 불러낸 다음 "오프셋 테두리"를 선택합니다.

3.커서를 드래그하거나, 다른 편집 면을 선택합니다. 모프 테두리와 그것의 인접면들을 선택한 편집면을 따라 움직입니다.

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/040_elementsvb/OffsetMorphEdge.png     https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/040_elementsvb/OffsetMorphEdge2.png

4.클릭하여 완성합니다.

모든 모프 테두리 오프셋

1.모프를 선택합니다.

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/040_elementsvb/BoxMorphBegin00181.png 

2.테두리에서 펫 팔레트를 불러와 "모든 테두리 오프셋"을 실행합니다.

3.커서를 드래그하거나, 다른 편집면을 선택합니다 (인접 면들만을 선택할 수 있음). 클릭한 테두리와 인접한 편집평면에 누운 면)은 선택한 편집 평면을 따라 모든 면에서 오프셋됩니다.

4.클릭하여 완성합니다.

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/040_elementsvb/OffsetAllMorph1.png     https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/040_elementsvb/OffsetAllMorph2.png

https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/040_elementsvb/OffsetAllMorph3.png     https://helpcenter.graphisoft.com/kr/wp-content/uploads/sites/7/archicad-24/040_elementsvb/OffsetAllMorph4.png

  • Was this Helpful ?
  • YesNo