Model Display of the 3D Document

While the 3D Document derives many of its settings from its 3D window source, several important settings for the 3D Document’s model appearance are derived from 3D Document Settings.

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/050-viewsvb/3DDocComposite.png 

See 3D Document Model Display Panel.

Use the 3D Document Settings Model Panel to set:

Fills and pens for element surfaces and contours, and for cut elements

Transparency

Vectorial 3D hatching

Sun and Shadow effects

Hidden Edges

Boundary Contours (for Floor Plan-based 3D Documents)

Important: These settings apply to the 3D Document and are independent of its source window.

  • Was this Helpful ?
  • YesNo
Relevant topics
Model Display in the Section Window
Note: The controls for the display of elements is nearly identical for Elevations and Interior Elevations, and for 3D Documents based on the Floor ...
Column Model Display
Use the Model Panel of Column Settings (Segment page) to override Column surface(s).   Override Surface: Click to override the surfaces assigned to this column or segment in its Building Material: •Top and Bottom Surfaces •Side (Extrusion) Surfaces Note: For Columns ...
Beam Model Display
Use the Model Panel of Beam Settings (Segment page) to override Beam surface(s).   Override Surfaces: Each side of the Beam is listed. Click the icon of the Beam side(s) to override that surface (assigned via its Building Material). •For a rectangular Beam: Override left side, ...