These settings are available if you chose a Cantilever Structure type for the Flight and/or Landing.
Choose a Cantilever Component type - e.g. Bracket or Block.
Use the Cantilevered Component Panel to configure the chosen structure. Some options are pictured below:
•Set cantilever structure on left, right, or both sides of Stair
•Add an optional Tread Plate
•Add an optional Wall Fixing
Brackets on Left Side
Cantilever using Tread Plate and Wall Fixing |
Cantilever Both Sides, with Stringers |
Relevant topics
Stringers Flight and Landing Structure
This page is shown in the Stair Settings tree structure
•if the Flight or Landing Structure is set to Stringers Only, or
•if the ...
Monolithic Flight and Landing Structures
These settings are available if you chose a Monolithic Structure type for the Flight and/or Landing.
See Choose Structure Type.
...
Flight and Landing Structures
In Stair Settings, select the Structure node in the tree to open the Structure tab page.
Use this page to select Structure types for the Stair ...