Publishing Process

If you have finished setting up the publication but do not want to actually start publishing, you can simply close the palette without clicking the Publish button. All Publisher settings are preserved with the project.

A log file containing information on each publishing process is saved to the location you specify in Options > Work Environment > Publisher (“Publisher log location”).

If you have selected a Publisher Set containing Layouts:

Use the scroll-down list at the bottom of the Publisher to choose which item(s) to output:

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/070-documentation/LayoutsInCurrentIssue00096.png 

This set: the entire active publisher set

Selected items: Only items currently selected in the active publisher set

If you are viewing the list of Publisher Sets:

Sets affected by current issue: All publisher sets that contain at least one layout that is part of the current issue. (Such publisher sets are listed in green.)

See also Revisions in the Publisher.

All the sets: all currently defined publisher sets.

Layouts in current issue: All layouts of the active publisher set that are part of the current issue. (Such Layouts are listed in green.)

Note: In Teamwork: Do not do a Receive between the time that you Close the Issue and publish the Issue, because the Drawings might change as a result; yet these changes cannot be updated on the Revision, which has already been frozen.

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/070-documentation/LayoutsInCurrentIssue00097.png 

Click the Publish button at the bottom of the Publisher to begin the publishing process.

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/070-documentation/PublishProcess.png 

To end the whole publishing procedure, click Stop. To pause it, click Pause; the Stop button changes to Continue, allowing you to continue publication later.

A log file containing information on each publishing process is saved to the location you specify in Options > Work Environment > Publisher (“Publisher log location”).

Revisions of Publisher Items

Often, you may need to output a Publisher item multiple times to keep pace with revisions. You may wish to keep the older published files as a record.

The file name of each output Publisher item is identical to the name of the Publisher item itself. This means that if you output a Publisher item, and later rename it to reflect a new revision, you can re-publish it under the new name, without overwriting the previously output file, as was the case in older ARCHICADs.

If you publish multiple items of the same name simultaneously, a yellow warning triangle appears in the Publishing process window; double-click to read the message, as shown below. ARCHICAD will automatically rename such files.

//helpcenter.graphisoft.com/wp-content/uploads/ac22_help/070-documentation/PublishProcessError.png 

See also Republish Hyper-model.

  • Was this Helpful ?
  • YesNo
Relevant topics
Routing Process
1.Click Start Routing at the bottom of the MEP Routing palette. Note: Make sure the Autogroup function (Edit > Grouping > Autogroup) is turned off. 2.Click and drag in the active window, as with polyline input, then keep clicking to place additional segments on ...