Floor Plan Cut Plane Settings Dialog Box

Use Document > Floor Plan Cut Plane to open the Floor Plan Cut Plane Settings dialog box.
The other options in this dialog box – Relative Floor Plan Range and Absolute Display Limit – will be applied only to construction elements whose “Show Projection” setting (in the Settings dialog box) is set to use one of these two definitions. These definitions set a limit on how much of the element is to be displayed, relative to the current story.
Show up to: Enter the number of stories you want to display the element above the current story.
Offset by: Optionally, enter a positive or negative elevation value by which to offset the “Show up to” display limit.
Story pop-up: Choose either Current Story or, if you want to display the element on additional stories above the current one, Story(s) above.
Show down to: Enter the number of stories you want to display the element below the current story.
Offset by: Optionally, enter a positive or negative elevation value by which to offset the “Show down to” display limit.
Story pop-up: Choose either Current Story or, if you want to display the element on additional stories below the current one, Story(s) below.
Show down to: Enter the fixed lower limit to which elements will be projected. (By default, this is Project Zero.)
Offset by: Optionally, enter a positive or negative height value by which to offset the “Show down to” absolute display limit.
  • Was this Helpful ?
  • 0   ​40