Set Routing Preferences

Set the desired options on the MEP Routing palette (Window > Palettes > MEP Routing) These options can be changed in the midst of a routing operation, so that each element can use separate options.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-22-mep-modeler-user-guide//RoutingPalette00001.png 

1.Choose either Ductwork, Pipework or Cable Tray from the top dropdown menu.

2.Choose a cross-section geometry preference for the routed elements: Rectangular, Circular, Oval or (with Ductwork only) Flexible.

Enter height and width values for the cross-section. (Enter a predefined value from the pop-up, or type in any value.) The list of predefined Duct and Pipe sizes can be edited in MEP Preferences. (Design > MEP Modeling > MEP Preferences).

3.Choose a Construction Method by clicking on one of the four icons. (Can also be set in the Tracker.)

Every routing operation begins at the elevation set as “Constant Elevation” (the horizontal arrow). Once you click in the window to begin routing, you can switch to another construction method if you want to change the routing elevation as you proceed. (See Vary Elevations During Routing.)

4.Choose an MEP System attribute for this Routing operation.

5.Reference Line location: Choose one of the nine points in the Routing palette to define the location of the reference line of the routed elements. (The Reference Line is relevant only during a Routing operation, and indicates the anchor point of the routed elements when you click on screen to place them.)

In this image, the Reference line during routing runs along the top left corner of the duct, as viewed in the direction of routing.

https://helpcenter.graphisoft.com/wp-content/uploads/archicad-22-mep-modeler-user-guide//Alignment.png 

You can switch the reference line location at any time during a routing operation.

6.Adjust Routing Options as needed. (See Routing Options.)

7.Choose a Layer on which to place the routed elements.

  • Was this Helpful ?
  • YesNo
Relevant topics
Start Routing
Click Start Routing at the bottom of the MEP Routing palette. The button’s text changes to Stop Routing, indicating that Routing is in progress. The Toolbox automatically switches to the relevant straight segment-type tool (Duct, Pipe or Cable Tray). Click in the active window to ...
Start Routing by Placing Junction on a Placed MEP Element
You can begin a Routing operation by placing a junction at an already placed straight MEP segment. •Click Start Routing on the MEP Routing palette •Click on the centerline of a placed MEP element The Routing will begin at the place you clicked, by inserting a Junction. The ...
Finish Routing
Click the Finish Routing button at the bottom of the Routing palette, or Double-click to complete a Routing operation. You can also finish Routing by connecting to an already placed MEP element: click on the connection port of the placed element. If the connection geometries of the ...