Use this method to place a vault-shaped Shell profile, then extrude it graphically.
The Shell’s profile here is always a half-circle (vault). (You can edit the profile later.)
1.Activate the Shell Tool and choose the extruded geometry method with simple input method.
On the Floor Plan or 3D Window:
2.Click twice to define the Shell’s extrusion length.
3.Click a third time to define the width of the Shell Profile.
4.The Shell is complete.
Relevant topics
Simple Extruded Vault: Perpendicular to the Floor Plan
Use this method to place a vault-shaped Shell profile, then extrude it up or down (perpendicular to the Floor Plan).
The Shell’s ...
Floor Plan/Reflected Ceiling Plan Display (Stair Settings)
Each Stair has two groups of settings, defining display preferences for the Stair Symbol (and its components) on Floor Plan and on Reflected ...
Beam Display on Floor Plan and Section
Use the Floor Plan and Section page of Beam Settings.
See Element Display in Floor Plan and Section.
Projection Mode
Once you have set Floor Plan Display, use Projection Mode to fine-tune each displayed component (Overhead, Uncut) of the Beam: as either Symbolic or Projected.
...