Slab Listing Parameters

Note: Even if the listed Slab edge has a custom surface, the listed surface is the Slab’s edge surface as shown in the Model panel of Slab Settings.
Surface area of the bottom of the Slab, subtracting the surface of any openings that exceed a given area as defined in Options > Project Preferences > Calculation Units & Rules (“Reduce Slab surface by…”). Takes trims and SEO’s into account.
Surface area of the top of the Slab, subtracting the surface of any openings that exceed a given area as defined in Options > Project Preferences > Calculation Units & Rules (“Reduce Slab surface by…”).
Takes trims and SEO’s into account.
Volume of the Slab, subtracting the volume of any openings that exceed a given size as defined in Options > Project Preferences > Calculation Units & Rules (“Reduce Slab volume by…”). Takes trims and SEO’s into account.
  • Was this Helpful ?
  • 0   ​1