Rebuild Trace Reference

Use the Rebuild command (available from the Trace & Reference Palette or among the Trace Reference commands) to rebuild the Reference to reflect any changes in the source view.
If the Reference is an Auto-Rebuild Model, it is possible that you make changes in the Active, yet these are not reflected in the Reference, even after you navigate or pan, because – to avoid slowing down the program – you have unchecked “Update Autorebuild Model Viewpoints continuously” in Options > Work Environment > Model Rebuild Options. Use the Rebuild Reference button when needed.
If the Reference contains an Auto-update Drawing, such a Reference will not be continuously rebuilt, to avoid slowing down the program. Use the Rebuild Reference button when needed.
  • Was this Helpful ?
  • 0   ​0