Edit Shell Hole

Note: When selecting the hole, you must click the hole on the side of the Shell that coincides with the profile line. Hole edge selection is not available on the side of the Shell opposite to the profile line.
To limit the extent of the hole’s cutting body, select the hole and use the Edit Extrusion Length command from the pet palette to change the length of the cutting body. This way, for example, you can eliminate a hole created by a cutting body that runs through both sides of your Shell.
Turn Hole Plane: This command rotates the hole plane, and thereby changes the hole geometry within the Shell. You can also rotate the hole itself.
Select the Turn Hole Plane command. Define the rotation arc, then move the cursor to rotate the plane.
Drag, Rotate, Mirror Hole: These edits move the hole on its own plane.
  • Was this Helpful ?
  • 1   ​0